Sonic Blue Replay TV 5000 - Manual (Page 11)

5
Connections
G
e
tting
Sta
rted
Se
tu
p
Basi
c
Ope
rations
Ad
vanc
e
d
Fe
atures
He
lp
:: Rear Panel Overview
1 OUT TO TV Connect to a television VHF/UHF jack with coaxial cable.
2 IN FROM ANT/CATV Connect an antenna, cable TV coaxial cable, or cable box with coaxial cable.
3 VIDEO/AUDIO IN 1/IN 2 Connect to the Audio/Video outputs of a cable box or satellite receiver using standard audio/
video cables.
4 S-VIDEO IN Connect to a cable box or satellite receiver that has S-Video Out. The Audio/Video IN 2 connectors must be
used with S-Video to receive sound. Please note that S-Video In is part of Line 2.
5 VIDEO/AUDIO OUT 1/OUT 2 Connect to the Audio/Video inputs of a television, monitor or A/V receiver using stan-
dard audio/video cables.
6 PROGRESSIVE OUT Connect to a television, monitor or A/V receiver that has Progressive Video In.
7 POWER CORD Connect to an electrical outlet.
8 S-VIDEO OUT Connect to a television, monitor or A/V receiver that has S-Video In. Please note that Video Out 1, Video
Out 2 and S-Video are active at all times.
9 DIGITAL AUDIO OUT (OPTICAL) Connect to an audio/video receiver equipped with an optical input.
10 SERIAL CONTROL Connect to a satellite receiver that has a Serial port. This allows ReplayTV to change the channels on
the satellite receiver. The IR Blaster is not needed if the satellite receiver has Serial Out.
11 IR BLASTER Connect and affix the IR emitter over the infrared detector on a cable box or satellite receiver. This allows
ReplayTV to change the channels on these devices.
12 NETWORK ACTIVITY AND LINK LIGHTS Indicate the status of ReplayTV when using the Ethernet port. The green
light indicates that ReplayTV is connected to the network. The yellow light indicates network activity; i.e., data is being trans-
ferred to or from the unit.