Sun Microsystems Ethernet MMF/UTP Adapter - Manual (Page 120)

86 Sun PCI-Express Dual Gigabit Ethernet MMF/UTP Adapter Installation and User’s Guide • June 2006
▼ To Configure Bonding for Multiple e1000
Interfaces
1. Modify the /etc/modules.conf file for 2.4 kernels or the /etc/modprobe.conf
file for 2.6 kernels file by adding these lines:
where:
■ bond0 is the bonding device.
■ max_bonds is the number of bond interfaces to be created.
■ mode specifies the bonding policies.
■ miimon is the frequency in milliseconds that MII link monitoring will occur.
Refer to Linux documentation for more information.
2. Load the bonding driver:
3. Configure bond0 interface.
In this example, bond0 is the master of the two interfaces eth2 and eth3.
alias bond0 bonding
options bonding max_bonds=2 mode=4 miimon=1000
# modprobe bonding
# ip addr add 192.12.38.64/24 brd + dev bond0
# ip link set dev bond0 up
# ifenslave bond0 eth2 eth3