Using the diversity receiver – Sennheiser EK 300 IEM User Manual

Page 10

Advertising
background image

9

Using the diversity receiver

Using the diversity receiver

To establish a transmission link, proceed as follows:

1. Switch the diversity receiver on (see next section)

2. Switch a transmitter on (see the instruction manual of the trans-

mitter).
The transmission link is established and the receiver’s RF level display

RF

reacts.

If you cannot establish a transmission link between transmitter and
receiver, read the chapter “Synchronizing an SR 300 IEM G3 transmitter
with the diversity receiver” on page 20.

Switching the diversity receiver on/off and adjusting
the volume

To switch the diversity receiver

on

:

̈

Turn the volume control

³

clockwise until it clicks.

The red

ON

LED

¿

lights up. The “

Frequency/Name

” standard display

appears on the display panel.

To switch the diversity receiver

off

:

̈

Turn the volume control

³

counterclockwise until it clicks.

The red

ON

LED

¿

goes off and the diversity receiver switches off.

To adjust the

volume

:

̈

Turn the volume control

³

.

It is vital to observe the notes on frequency selection on page 20.

CAUTION!

Hearing damage due to high volumes!

Listening at high volume levels for long periods can lead
to permanent hearing defects.

̈

Set the volume to a low level before putting the
earphones on.

̈

Do

not

continuously expose yourself to high volumes.

Advertising