SVAT Electronics CVDVR200 - Manual (Page 4)

INSTALLATION
1. Hard Disk installation
The system supports Dual Hard Disk recording feature. Please carefully follow the
steps as below to install Hard Disk Driver. Install the Hard Disk into mobile rack
When the Hard Disk is installed, you have to lock the mobile rack so that the
DVR system can work.
Replace the Hard Disk from DVR
1. Press STOP button to stop recording.
2. Turn off the power of DVR.
3. Take out the Hard Disk from mobile rack and/or fixed hard disk rack.
4. Insert the new Hard Disk.
5. Lock the mobile rack again.
6. Turn on the power of mobile rack.
7. Press REC button for recording.
SENSOR & ALARM INSTALLATION
When you want to install the sensor and/or alarm to the DVR, please refer to the
following picture for installation.
1. Sensor
Connect the wire one end to sensor and the other end to the sensor terminal.
The adapter has to be inserted to the sensor when the wire is connected. If you
don t know positive or negative while installing sensor output wire, the cross test
can be done and see if it can work normally.
1.Take out the
mobile rack.
2.Take off the
top cover
3. If you decide to use two
Hard Disks in the colour
mintor with the DVR system.
you have to designate one
as a master and the other
as a slave.
4. Connect the cable
and power cord.
5.Screw the hard
disk on.
6.Close the top cover and
insert the mobile rack to
colour monitor with DVR.