SVAT Electronics CVDVR200 - Manual (Page 7)

OPERATION
CONTINUED
Watch & View Control
1. This View button controls FULL SCREEN display from camera 1.
2. This View button controls FULL SCREEN display from camera 2.
3. This View button controls FULL SCREEN display from camera 3.
4. This View button controls FULL SCREEN display from camera 4.
5. This View button controls QUAD SCREEN, displays all cameras.
In the HARD DRIVE SETUP menu, the system will display the hard disk usage.
Record Control
1. When the red [RECORD] button is pressed, the recording process starts
immediately. The recording channel indicator next to CH1, CH2, CH3, CH4
will appear in the center of the screen to notify the user which camera is
running during the period of recording.
2. While the system is in recording mode, it will display the current writing hard
driver ID on the bottom line, [M] or [S] ([M] = MASTER, [S] = SLAVE), and will
show the percentage of hard disk recording capacity.
3. If the system has detected hard disk is going to end and the user presses
record button, the display will show warning message. During recording, if
the system has detected hard disk recording capacity is going to end, it will
notify the hard disk full warning by displaying the current hard disk ID in
blinking.
* Please make sure the Time is correct before recording. If no, please refer to
Time Set section to change the time.
Keylock Control
Press the red [RECORD] button and hold it for 2 seconds or longer, the recording
process starts immediately. But, the button has been locked. To stop the record-
ing function, the user will be requested to key in the password.
Playback Control
The system allows the user select hard disk ID (Master or Slave), Event and
Start time to play contents in SEARCH TIME menu.
When the [ ] play button is pressed, the screen will display Hard driver ID
(Master or Slave) and all events recorded in this hard drive (Max. 95 events
will be recorded at each hard driver).
To select hard drive for playback
If you want to select hard drive other than shown on display for playback,
press [ ] button then the [>] select mark will skip to hard drive select section,
then press [SELECT] button to change hard drive ID, the screen will show
other driver ID and event list.
To playback the latest event
Press the [ ] play button again the screen will show last recorded event.
To select event for playback
Press [ ] key or [ ] key to select the event, then press the [ ] play button,
the screen will start to play the selected event till last event.