Sony MZ-NH900 - Manual (Page 92)

92
The recorder skips to
the next or previous
group (or skips several
tracks ahead or
behind) when you
press the 5-way
control key towards
. or >. • You pressed GROUP before pressing the 5-way control key towards
. or >.
, The recorder returns to normal if no operation is made for 5
seconds.
The edited tracks may
exhibit sound dropout
during search
operations. • This occurs due to the MiniDisc system limitation. The
fragmentation of data may cause sound dropout while searching
because the tracks are played in higher speed than normal playback.
There is no R-channel
sound output when
playing a track
recorded from a
cassette deck or
through an amplifier,
or when listening to
sound from a cassette
deck or amplifier. • There is no R-channel output if the cassette deck or an amplifier is
connected with a monaural cord.
, Make sure to use a stereo connecting cord. If, however, the
connected equipment is monaural, there will be no R-channel
sound output even with a stereo connecting cord.
While editing
Symptom Cause/Remedy
“NotENOUGH
POWER TO EDIT”
appears and editing
cannot be done on a
1GB Hi-MD disc. • Editing is not possible when using a 1GB Hi-MD disc even when the
battery level indication shows enough power remaining while the
recorder is stopped or playing. This is because of a mechanism that
disables editing when the remaining battery power is estimated by
the recorder to be insufficient due to the high power consumption
required for 1GB Hi-MD disc editing.
, Connect the AC power adaptor to the recorder or insert a fully
charged rechargeable battery or a new alkaline dry battery.
The lid does not open. • The power sources have been disconnected during recording or
editing, or the battery have been exhausted.
, Set the power sources again, or replace the exhausted battery
with new ones.
Editing cannot be
done. • The power source has been disconnected or a power outage has
occurred during editing.
, The editing done to that point is not saved to the disc. Do the
editing operation again.
Non-audio data
cannot be erased • Non-audio data cannot be erased with the Erase function.
, Confirm the contents by connecting the recorder to your
computer. If it is okay to delete the contents, then perform the
Format function (page 73).
Symptom Cause/Remedy