Samsung VP-D451 - Manual (Page 21)

✤ The amount of continuous recording time available depends on.
- The type and capacity of the Battery pack you are using.
- How often the zoom function is used.
It is recommended that you have several batteries available.
1. Attach the Battery pack to the Camcorder.
2. Connect the AC Power adapter to an AC Cord
and connect the AC Cord to a wall socket.
3. Connect the DC cable to the DC jack socket on
the Camcorder.
4. Turn the Power switch to OFF, and the
charging indicator will start to flash, showing
that the battery is charging.
5. When the battery is fully charged, disconnect the Battery
pack and the AC Power adapter from the Camcorder.
Even with the Power switched OFF, the Battery pack will
still discharge.
[ Notes ]
■ The Battery may contain a slight charge at the time of
purchase.
■ To prevent reduction in the life and capacity of the Battery pack,
always remove it from the Camcorder after it is fully charged.
■ The amount of continuous recording time available depends on:
-
The type and capacity of the Battery pack you are using.
- How often the zoom is used.
- Type of use (Camcorder/Camera/With LCD screen etc.).
- Ambient temperature.
It is recommended to have additional battery packs available.
■ Even when the Power switched Off, the Battery pack will still
discharge if it is left attached to the device.
Preparation
Using the Lithium Ion Battery Pack
Charging the Lithium Ion Battery Pack
Blinking time
Once per second
Twice per second
Three times per second
Blinking stops and stays on
On for a second and off for a second
Charging rate
Less than 50%
50% ~ 75%
75% ~ 90%
90% ~ 100%
Error - Reset the Battery pack and the DC cable
ENGLISH
21 21
✤
1.
2.
3.
4.
5.
■
■
■
■
Power Switch
4
< Charging indicator>
1 1 50%
1 2 50% 75%
1 3 75% 90%
90% 100%
1 1 -