Sanyo DS25520 - Manual (Page 7)

7
USING THE MULTIMEDIA REMOTE CONTROL
REMOTE CONTROL KEYS
➀
Mode Keys—Use these keys to program the
remote control and to select the operating mode
(VCR, TV, or AUX). To Operate Your...
VCR—Press the VCR key; Cable Box or DVD
Player—Press the AUX key; and Television—Press
the TV key.
Note: Make sure you hold down the mode key
while entering a code number, see page 8.
➁
Input Key—Press to select the program source to
watch: TV signal or signal from the DVD Player or
other equipment you have connected to the A / V
jacks.
➂
Number Keys—Two keys must be pressed to select
a channel. Example: Press 0 then 6 to select channel
6. For cable channels 100 through 125, press and
hold the 1 key until C1– – appears. Then press the
other two numbers.
➃
Caption Key (See page 12.)
➄
Menu Key—Use this key with the ▲/▼ and – /+
keys to navigate and adjust features of the
on-screen menu system (see pages 11 ~ 12).
➅
Channel Scanning (CH ▲/▼ ) and Volume
(VOL – /+) Keys—Press to scan through the
channels in memory and to adjust the volume.
➆
Mute Key—Press once to minimize the volume.
Press again to restore. Note: When using the audio
out jacks this key will not mute the sound.
Operates your TV, VCR, DVD, and Cable converter box. To program the remote control,
see pages 8 ~ 10.
INSTALL BAT TERIES AS SHOWN (2 AA, not included)
Notes:
– Do not mix old batteries with new ones or mix
different types of batteries together.
– Remove the batteries if the remote control will not be used for
a month or more. Weak batteries may leak and cause damage.
(Normal battery life is roughly six months.)
IMPORTANT NOTE: Spent or discharged batteries must be recycled or disposed
of properly in compliance with all applicable laws. For detailed information,
contact your local County Solid Waste Authority.
QuickTips
■
Be sure batteries are
installed correctly.
■ Point the remote
control toward the
equipment you want
to operate. Objects
between the remote
control and the equip-
ment may cause
misoperation of the
remote control
function.
■ If the remote control
does not work: Press
T V key (see item 1).
■ The remote control
must be programmed
before it will operate
your VCR, DVD, or
Cable Box. See
pages 8~10.
■ Cannot select
channel with number
keys. Press “0 ”in
front of numbers
1 ~ 9. Example:
Channel 05.
■
Adjusting the volume
level: Right flashing
arrow indicates
volume is increasing
and Left flashing
arrow indicates
volume is decreasing.
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
RECALL
DISPLAY MUTE
MENU
CAPTION SLEEP
RESET INPUT
CH
VOL VOL
POWER
VCR TV AUX
1 2 3
4 5 6
7 8 9
0
1 2 3
4 5 6
7 8 9
0
➀
➁
➂
➃
➄
(Continued on page 8.)
➅
➆