Removing the door, 3 oven door seal, Instructions for the user – Smeg SA704X-5 User Manual

Page 27

Advertising
background image

Instructions for the user

29

8.2

Removing the door

Open the door completely and fit the pins (supplied) into the holes from the inside.
Close the door to an angle of about 45°, lift it and remove it from its seat. To
replace, fit the hinges into the grooves provided, then lower the door until it comes
to rest and extract the pins. If the pins are lost, two screwdrivers can also be used.




8.3 Oven door seal

To permit thorough cleaning of the oven, the seal
may be removed. Before removing the seal, take off
the door as described above. Once the door has
been taken off, lift the tabs at the corners as shown
in the figure.
After cleaning, refit the seal with the longer side
horizontal and insert the tabs into the appropriate
holes starting from the top ones.

Advertising
This manual is related to the following products: