Sirius Satellite Radio SIRIUS InV2 - Manual (Page 36)

[
Installation
] 36
Connecting Your SIRIUS InV2 to Your Vehicle’s Audio
System
There are two ways to connect your SIRIUS InV2 to your vehicle’s audio system:
Direct Connection or Wireless Connection. Which one will perform best in your vehicle
depends on your vehicle’s audio system.
For the latest information go to http://www.sirius.com/vehicleinstallation.
Direct Wired Audio Connection
If your vehicle’s audio system has an “A UX I N ” or “L INE I N ” jack it is the best-quality audio
connection you can use for your SIRIUS radio. (And if the A UX I N or L INE I N connector is
located somewhere on the front of your vehicle radio or elsewhere in the cabin, this is
also the easiest way to connect your SIRIUS receiver.)
1. Purchase an audio cable that matches the connection type of your vehicle’s audio
system and your SIRIUS InV2 unit at your local electronics retailer.
• The InV2 unit requires a male 1 /
8
” stereo connector.
2. Plug the cable’s male 1 /
8
” stereo connector into the A UDIO jack on the left side of the
InV2 unit. Plug the other end into the A UX I N /L INE I N connector on your vehicle’s audio
system. (See Figure 16.)
Stereo Cable
(Sold Separately)
A UDIO
Jack
Vehicle Radio
To A UX I N
or L INE I N
Connector
InV SI2 Unit
(Left Side)
Figure 16