Swisher Truck Spreader 11730 - Manual (Page 4)

Item # Part # Description
9 10111TK Bracket - Motor Support, Upper
11 10114TK Bracket - Motor Support, Lower
12 10197 Bolt - Carriage 5/16-18 X 1 GR5
13 10117TK Shield - Spreader
14 3844 Knob - T, 5/16-18
15 15118 Motor - Spreader 12 VDC CW 2.5"
16 10118 Spinner - Distributor, Spreader
Step 3:
Remove the nuts and snap ring from
the motor and place the Lower Motor
Support Bracket (11) over the Motor (15).
Thread the nuts onto the motor studs and
tighten. Slide the Spinner/Distributor (16)
over the motor shaft and replace roll pin.
Step 4:
Insert the 5/16” Carriage Bolts (12)
into the Lower Motor Bracket (11),
through the Upper Motor Bracket (9),
and through the Spreader Shield (13).
Place the T-Knobs (14) on the bolts (12)
and tighten. (The guide of the
Lower Bracket will slide up
through the slot in the Upper
Bracket).
NOTE: To change the radius of
material being spread, simply
loosen the T-Knobs and slide
the mechanism up (smaller
radii) or down (larger radii).