Star Micronics SP2000 Series - Manual (Page 9)

– 6 –
ENGLISH
4. Optional AC Adapter
Use the following procedure to install the optional AC adapter.
Fig. 4-2 Flat side faces this way
1 Turn the printer over.
2 Plug the AC adapter’s cord into the socket as shown in the above illustration.
Make sure the flat side of the plug is facing towards the inside of the printer.
3 Use one of the nylon fasteners that comes with the printer to fasten the cord
at the point indicated in the illustration.
AC adapter cord
Cord holder
[Before AC adaptor installed] [After AC adaptor installed]
Fig. 4-1
AC adaptor
Power code
AC adapter Adapter holder Fasteners