Sony RDR-GX380 - Manual (Page 17)

17
H
ook
up
s and
Se
tti
n
gs
b Notes
• Do not connect your TV’s audio output jacks to the
LINE 2 IN (R-AUDIO-L) jacks at the same time. This
will cause unwanted noise to come from your TV’s
speakers.
• With connection B, do not connect the LINE 2 IN (R-
AUDIO-L) and AUDIO OUT (L/R) jacks to your TV’s
audio output jacks at the same time. This will cause
unwanted noise to come from your TV’s speakers.
• With connection A, after you have completed the
connection, make the appropriate settings in the
[Audio] setup (page 69). Otherwise, no sound or a loud
noise will come from your speakers.
• When you connect the recorder to an audio component
using an HDMI cord, you will need to do one of the
following:
– Connect the audio component to the TV with the
HDMI cord, or
– Connect the recorder to the TV with a component
video cord.
Step 4: Connecting the
Mains Lead (Power Cord)
Connect the supplied mains lead (the power cord)
to the AC IN terminal of the recorder. Then plug
the recorder and TV mains leads (AC power
cords) into the mains. After you connect the mains
lead (the power cord), you must wait for a
short while before operating the recorder.
You can operate the recorder once the front panel
display lights up and the recorder enters standby
mode.
If you connect additional equipment to this
recorder (page 22), be sure to connect the mains
lead (the power cord) after all connections are
complete.
*1
*2
~ AC IN
to mains
to AC IN 1
2