Sharp Insight Electric Rang - Manual (Page 8)


InstallatIon Manual
CaRE, ClEanInG anD MaIntEnanCE
Refer to the Operation Manual for cleaning instructions. If removing
the range is necessary for cleaning or maintenance, disconnect the
electrical power supply. If the electrical supply is inaccessible, lift
the unit slightly at the front and pull out away from the wall. Pull
only as far as necessary to disconnect the electrical supply. Finish
removing the unit for servicing and cleaning. Reinstall in reverse
order making sure to level the range and check electrical connections.
See pages 2 and 3 for proper anchoring instructions.
BEFoRE You Call FoR sERVICE
Read the BEFORE YOU CALL and operating instruction sections
in your Operation Manual. It may save you time and expense. The
list includes common occurrences that are not the result of defective
workmanship or materials in this range.
Refer to your Operation Manual for our service address. Sharp's
toll-free telephone number is 1-800-BE-SHARP (1-800-237-4277).
Please call or write if you have inquiries about your range product
and/or need to order parts.
note: Please do not open or close the lower oven door for 30
seconds after plugged in.
PRIntED In usa
TINSEB455MRR1
SHARP ELECTRONICS CORPORATION
Sharp Plaza, Mahwah, New Jersey 07430-2135
Figure 20
Visually check that rear leveling leg is inserted into and fully secured
by the Anti-Tip bracket by looking underneath the range with a
flashlight and carefully attempt to tilt it forward.
Slide range into cabinet
until control panel edge
is flush with the
countertop front edge.