Siemens Simatic 620 - Manual (Page 98)

Configuring the SIMATIC Box PC 620
5-10
SIMATIC Box PC 620 Manual
A5E00131465-01
”Boot Options” Submenu
The following submenu appears when you select the option “Boot Options” in the
main menu:
PhoenixBIOS Setup Utility
Item Specific Help
QuickBoot Mode:
ESC Exit
Select Item
Select Menu
+ / –
Select
Change Values
Sub-Menu
F9
F10
Setup Defaults
Save and Exit
SETUP prompt: [Enabled]
POST Errors: [Enabled]
Floppy check:
Allows the system to
skip certain tests
while booting. This
will decrease the
time needed to boot
the system.
Enter
Help F1
Main
Boot Options
[ Enabled ]
Summary screen:
[Disabled]
[Enabled]
Figure 5-5 ”Boot Options” Submenu
Quick Boot
Mode
Some hardware tests are skipped to speed up the boot procedure.
SETUP prompt The message PRESS <F2> to enter Setup appears at the bottom of the
screen during the system run-up phase.
POST Errors The boot process is stopped if an error is detected; you must press F1 to
acknowledge. Enter “Disabled”to avoid the necessity of acknowledging
errors, for example if no keyboard is connected.