Savin 9922DP - Manual (Page 97)

What to do If Something Goes Wrong
86
3
If You Cannot Make Copies as You Want
Adjust Image
Problem Cause Action
Copies are not sta-
pled. There are jammed staples in
the stapler. Remove jammed staples. See
⇒
P.109 “e Removing Jammed
Staples” .
Note
❒ After removing jammed
staples or adding staples,
staples might not be eject-
ed the first few times you
try to use the stapler.
The number of copies exceeds
the capacity of the stapler. Check the stapler capacity.
See
⇒
P.38 “Staple”.
The stapler has run out of sta-
ple. Add staples. See
⇒
P.107 “d
Adding Staples” .
Staples are wrongly
positioned. Originals are not set correctly. Set originals correctly. See
⇒
P.38 “Staple”.
Misfeeds occur fre-
quently. Copy paper size setting is not
correct. Set the proper paper size. See
⇒
P.103 “Changing the Paper
Size” .
You cannot combine
several functions. Selected functions cannot be
used together. Refer to the combination
chart. See
⇒
P.80 “Combina-
tion Chart” .
Problem Cause Action
In Center/Border
mode, parts of the
original image are not
copied. The margin is too wide. Set a narrower margin with
the user tools. See “01. Border
Erase Width” in
⇒
P.121 “2.
Adjust Image 1/3” . See “02.
Center Erase Width” in
⇒
P.121 “2. Adjust Image 1/3”.
Your original has narrow
margins on four sides.
In Image Repeat
mode, the original im-
age is not copied re-
peatedly. You selected the same size
copy paper as originals, and
did not select the proper re-
production ratio. Select copy paper larger than
the originals. See
⇒
P.72 “Re-
peat Image—Repeating an Image
over the Entire Copy”
.
Select the proper reproduc-
tion ratio. See
⇒
P.72 “Repeat
Image—Repeating an Image over
the Entire Copy”
.