6 clock circuit, Table 4.6 lan9512 crystal specifications, Clock circuit – SMSC LAN9512 User Manual
Page 44: Datasheet
USB Hub with Integrated 10/100 Ethernet Controller
Datasheet
Revision 1.0 (04-20-09)
44
SMSC LAN9512
DATASHEET
4.6
Clock Circuit
LAN9512 can accept either a 25MHz crystal (preferred) or a 25MHz single-ended clock oscillator (+/-
50ppm) input. If the single-ended clock oscillator method is implemented, XO should be left
unconnected and XI should be driven with a nominal 0-3.3V clock signal. The input clock duty cycle
is 40% minimum, 50% typical and 60% maximum.
It is recommended that a crystal utilizing matching parallel load capacitors be used for the crystal
input/output signals (XI/XO). See
for the recommended crystal specifications.
Note 4.12 The maximum allowable values for Frequency Tolerance and Frequency Stability are
application dependant. Since any particular application must meet the IEEE +/-50 PPM
Total PPM Budget, the combination of these two values must be approximately +/-45 PPM
(allowing for aging).
Note 4.13 Frequency Deviation Over Time is also referred to as Aging.
Note 4.14 The total deviation for the Transmitter Clock Frequency is specified by IEEE 802.3u as
+/- 50 PPM.
Note 4.15 This number includes the pad, the bond wire and the lead frame. PCB capacitance is not
included in this value. The XO/XI pin and PCB capacitance values are required to
accurately calculate the value of the two external load capacitors. These two external load
capacitors determine the accuracy of the 25.000 MHz frequency.
Table 4.6 LAN9512 Crystal Specifications
PARAMETER
SYMBOL
MIN
NOM
MAX
UNITS
NOTES
Crystal Cut
AT, typ
Crystal Oscillation Mode
Fundamental Mode
Crystal Calibration Mode
Parallel Resonant Mode
Frequency
F
fund
-
25.000
-
MHz
Frequency Tolerance @ 25
o
C
F
tol
-
-
+/-50
PPM
Frequency Stability Over Temp
F
temp
-
-
+/-50
PPM
Frequency Deviation Over Time
F
age
-
+/-3 to 5
-
PPM
Total Allowable PPM Budget
-
-
+/-50
PPM
Shunt Capacitance
C
O
-
7 typ
-
pF
Load Capacitance
C
L
-
20 typ
-
pF
Drive Level
P
W
300
-
-
uW
Equivalent Series Resistance
R
1
-
-
50
Ohm
Operating Temperature Range
0
-
+70
o
C
LAN9512 XI Pin Capacitance
-
3 typ
-
pF
LAN9512 XO Pin Capacitance
-
3 typ
-
pF