Siemens Sinumerik 810T User Manual
Page 195
3 Operating Sequences
09.91
3.2.2 ”AUTOMATIC” operating mode - selection of the ”CURRENT VALUES” or ”CURRENT BLOCK” display
CURRENT
BLOCK
Operate the ”CURRENT BLOCK” softkey.
The ”CURRENT BLOCK” display for
the active program appears - program
” % 88 ” in this example.
(( 810T))
(( Bild 42 von Druckerei
einmontieren
Explantion of the ”CURRENT BLOCK” display
In addition to the displays already mentioned (”CURRENT VALUES”), the following are
displayed:
•
The block before the ”current block”, here block ”N 5”
•
The ”current block”, here block ”N 10”
•
The block after the ”current block”, here block ”N 15”.
Instead of the actual positions of the individual axes as shown in the “CURRENT VALUES”
display, the current G functions are listed here.
Note:
If the ”current block” consists of more than 41 characters, the following block is not
displayed!
Likewise, a block before or after the ”current block” with more than 41 characters is not
displayed.
User generated cycles are still displayed under “CURRENT BLOCK” after
a cycle disable.
3-92
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)