Sharp LL-T17A3 - Manual (Page 11)

11
English
Deutsc
h
Français
Italiano
Español
English
Connecting the monitor and turning the monitor on and off
CAUTION!
- When connecting, ensure that both the monitor
and computer are switched off.
- Be careful not to overly bend the cable or add
extension cords as this could lead to a
malfunction.
Connecting the monitor to a computer
- Paying attention to connector direction, firmly
insert the signal cable to terminal, and then
tighten the screws at both sides.
If connecting to a D-sub 15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal cable.
Note:
- When connecting to a notebook, if the notebook
computer's screen is set so that it is displaying at
the same time, the MS-DOS screen may not be
able to display properly. In this case, change the
settings so that only the monitor is displaying.
Analog RGB terminal
(Mini D-Sub 15 pin, 3 row)
Analog signal cable
Macintosh conversion adapter
Connect the accessory audio cable
Connecting the monitor to a power source
1.Connect the AC adapter to the monitor's power
terminal.
2.Attach the power cord to the AC adapter and
place the power plug into the AC outlet.
AC adapter
Power terminal
Power cord
AC outlet
Audio input terminal
Audio cable
Audio output terminal
02_LL-T17A3_gb.p65 10/3/2002, 12:01 PM 11