Sharp LL-T15S1 - Manual (Page 24)

24
4. Remove the four screws and then remove the stand
from the monitor.
5. Attach the arm to the monitor with four screws.
6. Connect the AC adapter to the monitor's power
terminal.
Instructions for installing a VESA compliant arm
Information
The stand is specially made for use with this
monitor. Once having removed the stand,
never attempt to attach it to another device.
Once having removed the screws, store
them together with the stand and if the stand
is ever re-attached be sure to use the
original screws.
Using different screws could lead to mal-
function
An arm based on the VESA standard can be attached to
the monitor. The arm must be purchased separately.
When choosing the arm to be installed please take note
of the following points.
-
The arm should be compatible with the VESA
standard, and there must be a gap of 75 mm x 75
mm between the screw holes on the section to be
attached.
- The arm must not fall off or break off after being
attached to the monitor.
Note:
-
Do not bend the RGB signal cable or the AC adapter
cable nor place weight on them. Doing so could lead
to damage.
1. Turn off the power switch and remove the AC adapter
from the monitor's power terminal.
2. Remove the stand cover.
Pull the lower section of the stand cover upward.
3. Being careful not to damage the monitor, spread out
a soft cloth and lay the monitor on it display-side
down.
Information
The screws used to
attach the arm should
be M4 screws with a
length of 4 mm ~ 6 mm
protruding from the
surface to be attached.
Using different screws
could lead to malfunc-
tion or may lead to the
monitor falling off,
internal damaged,
personal injuly.
4 ~ 6 mm
Screw used to
attach arm
Arm
Part of monitor to
which arm is
attached
Stand cover