Speco Technologies Color Video Monitor - Manual (Page 10)

FUNCTION DESCRIPTION for 14 / 15 / 17 / 21 Inch
REAR PANEL CONTROLS
7. VIDEO IN & OUT
These BNC Connectors permits ‘loop-through’ connection of a video signal in installations where it is desirable
to display the video signal on more than one monitor. A standard 1.0 vp-p video signal applied to the video
input will also appear at the video output . Use a coaxial cable with a BNC type plug for these connections.
8. AUDIO IN & OUT
The rear RCA connectors permit audio signal connection.
9. Y/C IN & OUT
Permit high resolution VCD, LD, DVD or V-cam signal input connection.
10. V1 AUI / V2 AU2
Permit V1 AU1 / V2 AU2 switch at user’s request.
11. HI / LO
This switch provides convenient selection of a ‘HIGH’ or ‘LOW’ for video input impedance. The switch should
be set to ‘HIGH‘ position when loop-through configuration is used or set to ‘LOW’ when the video signal is to
be terminated at the monitor.
12. Y/C / VIDEO
Controls for Y/C & video switch.
OPERATING THE MONITOR
1. Place the monitor where you plan to use it.
2. This monitor can be operated between 96VAC to 256VAC.
3. Plug the power cord into AC adapter on the wall.
4. Link the A/V terminal from your device into the video-in BNC connector of the monitor.
5. Press POWER switch and the POWER indicator will light. After approximately 10~30 seconds a picture will
appear.
6. The monitor will detect the frequency of the input signals automatically, and the display image may be able to
be adjusted through the function switch on FRONT CONTROL PANEL.
7
8
10 12 11
Color Monitor Instruction Manual
-9-
Grounding
Grounding
Y Signal
C Signal
AU1 AU2
V1 V2
V1 OUT
HI LO
V2 OUT AU1 OUT
VIDEO Y/C
AU2 OUT
V1 IN V2 IN AU1 IN AU2 IN
OUT
IN
Y/C
9