Smeg STA4645U - Manual (Page 17)

16
Rev 0.0
USER INSTRUCTIONS EN
If an alarm situation occurs, the dishwasher interrupts the current program and
signals the fault.
Alarms E1, E3, E4, immediately terminate the current program.
Alarms E5, E6 interrupt the current program and, after the problem has been
eliminated, resume the cycle.
To “reset” an alarm:
open or close the door, or switch the appliance on and back off again. At this
point, the dishwasher can be programmed again.
If the fault persists, contact the Authorized Technical Assistance Ser-
vice.
•
•
•