Smeg STA4645U - Manual (Page 9)

8
Rev 0.0
USER INSTRUCTIONS EN
Only run the soak program with half loads.
After using the above table to choose the most suitable washing cycle, pro-
gram the appliance.
Before starting a washing program, make sure that:
The water supply tap is open.
There is regenerating salt in the water softener tank (to add
salt, see the instructions in the general manual).
The correct amount of detergent has been added to the dis-
penser (to add detergent, see the instructions in the general
manual).
The spray arms are able to rotate freely and without obstruction.
The racks have been correctly loaded (see the instructions in the
general manual).
The dishwasher door is securely closed.
2.2.1 Switching on
Press the on/off button (ref. 1 fi g. 2-02) to start the dishwasher. Then wait for
one of the program indicator lights to turn on (ref. 2 fi g. 2-02).
2.2.2 Selecting and starting the program
Press the program selection button (ref. 3 fi g. 2-02) several times until
the indicator light corresponding to the required program turns on (ref. 2 fi g.
2-02);
if necessary, select, using the relative buttons, the complementary functions
you are interest in (e.g. “Programming delay”);
close the door; the program will start after about 2 seconds and the relative
indicator light will fl ash throughout the cycle (program running signal).
If the door of the dishwasher has not been closed or has been incor-
rectly closed, the washing cycle will not begin.
2.2.3 End of program
The end of the program is indicated by a brief acoustic signal and the (marked
by “end”) “auto delicate” and “extreme wash” program indicator lamps fl ash.
•
•
•
•
•
•
•
•
•