Sony DDM-2802CNU - Manual (Page 14)

14
Rear panel
Location and Function of Controls
1 R/G/B VIDEO IN connectors (BNC type)
These connectors are used for inputting the R (red), G
(green) and B (blue) signals. The connectors are
terminated at 50 ohms.
2 LANDING SENSOR connector (8 pin)
This connector is used when adjusting uneven color by
connecting the optional landing sensor DDM-LS10.
3 I/F connector (D-sub 15 pin)
This I/F (interface) connector is used when externally
adjusting distortion, convergence, color temperature,
etc. by connecting the optional Remote controller DDM-
RM10.
4 MAIN circuit breaker
Set this circuit breaker to the I (on)
position when using this unit.
5 HD input connector (BNC type)
This connector is used for inputting horizontal drive
pulses (HD). The connector is terminated at 75 ohms.
6 VD input connector (BNC type)
This connector is used for inputting vertical drive pulses
(VD). The connector is terminated at 75 ohms.
R/G/B VIDEO IN
connectors
LANDING SENSOR
connector
I/F connector
MAIN circuit breaker
HD input connector
VD input connector
POWER indicator
FAILURE indicator
ROTATION control
AC IN socket
7 POWER indicator (green)
This indicator lights when the POWER switch on the
front panel is turned on.
8 FAILURE indicator (red)
This indicator lights when the circuits inside the unit are
not functioning correctly. Should this lamp light up, turn
off the MAIN circuit breaker and consult Sony
representative.
9 ROTATION CONTROL
This control adjusts the picture rotation. Use a
screwdriver etc. to turn the control.
0 AC IN socket
Connect an AC power cord here.
Note
When connecting to
1 , 5 and 6 , use a double-shielded coaxial
cable.
Rotate the picture
clockwise Rotate the picture
counterclockwise