Stow Plaster and Mortar Mixer (Gasoline Engine/Electric Motor) MS-93 - Manual (Page 23)

STOW MS-93 MIXER — OPERATION MANUAL — REV. #5 (03/26/10) — PAGE 23
This section is intended to assist the operator
with the initial start-up of the STOW MS-93H
(gasoline engine) or STOW MS-93E (electric
motor) mixer. It is extremely important that this
section be read carefully before attempting to use
the mixer in the field.
DO NOT use your mixer until this section is thoroughly un-
derstood.
Starting (gasoline only)
The following steps outline the procedure for starting the en-
gine. Depending on the type of engine employed in the mixer
the steps may vary slightly. If your mixer has an electric motor
disregard this section.
1. Move the fuel shut-off lever (Figure 11) to the
ON position.
Figure 11. Fuel Shut-OFF Lever
2. To start a cold engine, move the choke lever (Figure 12)
to the CLOSED position.
Figure 12. Choke Lever
3. Move the throttle lever (Figure 13) away from the slow
position, about 1/3 of the way toward the fast position.
Figure 13. Throttle Lever
STOW MS-93 PLASTER/MORTAR MIXER — START-UP PROCEDURES
Failure to understand the operation of the STOW MS-93
series mixers could result in severe damage to the mixer
or personal injury.
See Figures 5 and 6 for the location of any control refer-
enced in this manual.
WARNING
CAUTION
NEVER operate the mixer in a confined
area or enclosed area structure that
does not provide ample free flow of air.
General Safety
Respiratory Hazard