Symbol Technologies VC5090 - Manual (Page 69)

Operating the VC5090 3 - 11
Using a Headset
You can use a stereo headset for audio communication when an audio enabled application is used. Symbol
recommends headset, p/n 50-11300-050 and adapter cable p/n 25-80634-01R. Plug the headset jack into the
mating connector on the adapter cable. Plug the adapter cable into the audio connector on the bottom of the
vehicle computer. Ensure that the vehicle computer’s volume is set appropriately before putting the headset
on. When a headset is plugged into the jack, the speaker is muted.
Figure 3-17 Audio Connection
Resetting the Vehicle Computer
There are two reset functions, warm boot and cold boot.
Performing a Warm Boot
A warm boot restarts the vehicle computer and saves all stored records and entries. In the Windows CE environment.
To perform a warm boot:
•
press the Power button and the
P2
button on the Quick Access Panel simultaneously
or
•
tap >
Programs
>
Warm Boot
.
Performing a Cold Boot
A cold boot restarts the vehicle computer. To perform a cold boot turn off the Main Power switch on the top of
the vehicle computer, simultaneously press the
P1
,
P3
and the
Power
button then turn on the Main Power
switch.
A cold boot also restarts the vehicle computer, but erases all stored records and entries in RAM. Data saved in
flash memory or a memory card is not lost. In addition it returns formats, preferences and other settings to the
factory default settings.
Adapter Cable
NOTE
Files that remain open during a warm boot may not be retained.