Carrying out network ping test, Setting of accept ip ad- dress, Accepting all ip addresses – Sharp XG-P610X User Manual

Page 39: Controlling the projector using rs-232c or telnet, Advanced[5]network ping test), Advanced[9]accept all ip addr)

Advertising
background image

-39

Controlling the Projector Using RS-232C or Telnet

Carrying out Network Ping
Test

(ADVANCED[5]Network Ping Test)

It is possible to confirm that a network connection
between the projector and a computer etc. is work-
ing normally.

1

1

1

1

1 Enter “5” and press the “Enter” key.
2

2

2

2

2 Enter IP address of device to be tested and

press the “Enter” key.
Display entered IP address (*1).
Display test result (*2).

Note

• If the “Enter” key is pressed without entering an

IP address, the Ping destination IP address used
previously is entered.

• If there is a fault with the connection, “Error: No

answer” is displayed after a 5 second retry. In this
case, please confirm the settings for the projector
and the computer, and contact your network ad-
ministrator.

Setting of Accept IP Ad-
dress

(ADVANCED[6]Accept IP

Addr(1) - [8]Accept IP Addr(3))

It is possible to improve security of the projector by
allowing connection from only a prescribed IP ad-
dress. It is possible to set up to three IP addresses
allowing connection to the projector.

1

1

1

1

1 Enter “6”, “7” or “8” and press the “Enter” key.
2

2

2

2

2 Enter numerical value and press the “Enter” key.

Display set numerical value (*).

Note

• To invalidate the Accept IP Addr being currently

set, enter “0.0.0.0”.

• If there is one or more Accept IP Addr being set,

no connections are allowed from IP addresses
that are not yet set. They can be cancelled using
[9]Accept All IP Addr.

Accepting All IP Addresses

(ADVANCED[9]Accept All IP Addr)

Removes IP addresses set with “Accept IP Addr”.

1

1

1

1

1 Enter “9” and press the “Enter” key.
2

2

2

2

2 Enter “y” and press the “Enter” key.

Note

• At the point in time where “y” was entered, the

numerical values for Accept IP Addr(1)-(3) are
reset to “0.0.0.0”.

• If “n” is entered, setting is not altered.

advanced>5
Ping dest IP addr :192.168.150.1
Please Enter

:192.168.150.152

(change) —> 192.168.150.152
32 bytes from 192.168.150.152: icmp_seq = 1, time = 0 ms
32 bytes from 192.168.150.152: icmp_seq = 2, time = 0 ms
32 bytes from 192.168.150.152: icmp_seq = 3, time = 0 ms
32 bytes from 192.168.150.152: icmp_seq = 4, time = 0 ms

1

2

*1

*2

advanced>6
Accept IP Addr(1) : 0.0.0.0
Please Enter

: 192.168.150.152

(change) —> 192.168.150.152

1

2

*

advanced>9
Accept All IP Addresses(y/n)? y

1
2

Advertising
This manual is related to the following products: