Sharp Aquos LC-37D90U - Manual (Page 22)

21
Basic adjustment settings
Press MENU and the MENU screen displays.
Press c/d to select “Setup”.
Press a/b to select “EZ Setup”, and then
press ENTER.
• If you already set the Secret No., go to step 4. If
not, skip to step 5.
Input the 4-digit secret number by using 0–9.
Press a/b to select the desired language
listed on the screen, and then press ENTER.
Channel search
Channel auto search makes the TV look for all channels
viewable in the set area.
NOTE
• If no channel is found, confi rm the type of connection made
with your TV and try EZ Setup again.
• If you select “Yes” for CABLE Analog and initiate the
channel search, the channel list for CABLE Digital will be
deleted.
EZ Setup
You can run EZ Setup again, even after setting up the
preset channels.
Language setting
Select from among 3 languages: English, French and
Spanish.
Channel Setup
If initial setup does not memorize all the channels in
your region, follow the instructions below to manually
memorize the channels.
Channel search
Channel auto search makes the TV look for all channels
viewable in the set area.
Press MENU and the MENU screen displays.
Press c/d to select “Setup”.
Press a/b to select “CH Setup”, and then
press ENTER.
• If you already set the Secret No., input the
4-digit secret number here. See page 56 for
setting a secret number.
Press a/b to select “CH Search”, and then
press ENTER.
NOTE
• If no channel is found, confi rm the type of connection made
with your TV and try channel search again.
• If you select “Yes” for CABLE Analog and initiate the
channel search, the channel list for CABLE Digital will be
deleted.
1
2
3
4
5
6
1
2
3
4
Press c/d to select “Yes” or “No” for AIR
Analog & Digital, then press b to move
down.
Press c/d to select “Yes” or “No” for
CABLE Analog, then press b to move down.
Press c/d to select “Yes” or “No” for
CABLE Analog & Digital, then press b to
move down.
Select “Search Start”, and then press
ENTER
.
• If you are only receiving an analog signal through
the cable, select “Yes” for CABLE Analog. If you
are receiving both an analog signal and a digital
signal through the cable, select “Yes” for CABLE
Analog & Digital.
Press c/d to select “Yes” or “No” for AIR
Analog & Digital, then press b to move
down.
Press c/d to select “Yes” or “No” for
CABLE Analog, then press b to move down.
Press c/d to select “Yes” or “No” for
CABLE Analog & Digital, then press b to
move down.
Select “Search Start”, and then press
ENTER
.
• If you are only receiving an analog signal through
the cable, select “Yes” for CABLE Analog. If you
are receiving both an analog signal and a digital
signal through the cable, select “Yes” for CABLE
Analog & Digital.
5
Press MENU to exit.
7
Press MENU to exit.
6