Sharp Aquos LC-37D90U - Manual (Page 36)

35
Press MENU to exit.
6
Setting the Recording Mode (i.LINK)
The function for automatically adjusting the recording
mode of connected i.LINK devices can be turned on or
off.
Since most of the currently available i.LINK devices
automatically recognize the transfer rates of the pictures
and sound being recorded and control the recording
mode accordingly, you should always set this Mode
to “Pass through” in normal circumstances.
Depending on the i.LINK devices used and the type of
broadcast being recorded, this TV may not adjust the
recording mode properly. In this case, please set the
“Recording Mode” to “Pass through”.
Press c/d to select “Digital Setup”.
Press a/b to select “i.LINK Setup”, and
then press ENTER.
Press a/b to select “Recording Mode”, and
then press ENTER.
Press MENU and the MENU screen displays.
Using external equipment
1
2
4
3
Press c/d to select “Auto” or “Pass
through”, and then press ENTER.
• Normally, this should be set to “Pass through”.
5
Setting the Standby Mode (i.LINK)
Power consumption during standby mode can be
minimized by changing the setting of the “Standby
Mode” in “i.LINK Setup”.
If you are not using i.LINK and want to save power at
the standby, select “Inactive” in “Standby Mode”.
Press c/d to select “Digital Setup”.
Press a/b to select “i.LINK Setup”, and
then press ENTER.
Press a/b to select “Standby Mode”, and
then press ENTER.
Press MENU and the MENU screen displays.
1
2
4
3
Press c/d to select “Active” or “Inactive”,
and then press ENTER.
5
NOTE
• When the main power of the TV is in standby mode (POWER
indicator lights off), i.LINK control commands cannot be
received from an i.LINK device. This does not change even
if the “Standby Mode” is set to “Active”. To control the
TV from an i.LINK device, turn the TV power on (POWER
indicator lights up in blue).
• Data cannot be relayed between i.LINK devices when
all the following conditions are met: 1) More than one
i.LINK device is connected to the TV with i.LINK cables,
2) “Standby Mode” is set to “Inactive”, and 3) The power
of the TV is in standby mode (POWER indicator lights off).
When the TV is connected between two i.LINK devices in
series, select “Active” in “Standby Mode” or connect the TV
at an end of the series as shown in the diagram.
Press MENU to exit.
6
Selected item
Active
Inactive
Description
Power continues to pass through the
i.LINK circuit so data can be relayed.
Power consumption is minimized
during stand-by mode. Data cannot
be relayed at this setting.