Sony HT-K170 - Manual (Page 19)

19
Additional Information
Specifications
Amplifier section
(DIN 1 kHz, 8 ohms)
25 W + 25 W
(DIN 1 kHz, 8 ohms)
Front: 25 W / ch
Center: 25 W
Rear: 25 W / ch
TV, VIDEO, DVD 2CH,
5.1 CH/DVD :
10 Hz - 50 kHz +0.5/–2 dB
WOOFER:
Voltage: 1 V
Impedance: 1 kilohms
Full mute
220 - 230 V AC, 50/60 Hz
115 W
430 x 274 x 64.5 mm
4.6 kg
Power output
Rated Power
Output at Stereo
mode
Reference
Power Output
Frequency
response
Inputs
Outputs
Muting
Power
requirements
Power
consumption
Dimensions
Mass (Approx.)
TV,
VIDEO,
DVD 2CH,
5.1 CH/
DVD
Sensitivity
250 mV
Impedance
50
kilohms
S/N
(weighting
network,
input level)
85 dB*
(A, 250 mV)
Full range, magnetically
shielded
5 cm cone type
Bass reflex
8 ohms
60 watts
84 dB (1 W, 1m)
150 Hz - 20, 000 Hz
Approx. 76 x 100 x 86 mm
including front grille
Approx. 425 g
Speaker system
Speaker units
Enclosure type
Rated
impedance
Power handling
capacity
(Maximum input
power)
Sensitivity level
Frequency range
Dimensions
(w/h/d)
Mass
General
Speaker section
SS-MS215 Front, center and rear
speakers
SA-WMS215 Subwoofer
System
Speaker system
Speaker unit
Enclosure type
Continuous RMS
power output
(8 ohms, 20 -
250 Hz)
Reproduction
frequency range
High frequency
cut-off
frequency
Power
requirements
Power
consumptions
Dimensions
(w/h/d)
Mass
Supplied
accessories
Active subwoofer,
magnetically shielded
Woofer: 16 cm cone type
Acoustically Loaded Bass
Reflex
50 W
32 Hz - 250 Hz
250 Hz
220 - 230 V AC, 50/60 Hz
45 W
Approx. 240 x 285 x 355
mm including front
panel
Approx. 8 kg
See page 4.
Input
General
LINE IN (input pin jack)
Design and specifications are subject to
change without notice.
Specifications indicated are measured at
230 VAC, 50Hz.
*78 IHF