Samsung WC12ZR - Manual (Page 8)

You must select the Cool mode if you wish to lower the temperature
in your room. You can also set the fan speed.
1 If necessary, press the (On/Off) button.
Result: ◆ The operating mode indicator (COOL or FAN) on the
unit comes on.
◆ The air conditioner starts up in the mode selected
when the unit was last used.
◆ The unit beeps twice.
☛
The air conditioner is fitted with a protection mechanism to prevent
the unit from being damaged when it is started immediately after
being:
◆ Plugged in
◆ Stopped
It will start up normally after a three-minute rest period.
2 If the COOL indicator is not lit up on the unit:
◆ Press the COOL button on the remote control
or
◆ Press the POWER/MODE button on the unit one or more times until
the COOL indicator lights up
Result: ◆ The unit beeps each time you press POWER/MODE.
◆ The air conditioner starts up in Cool mode.
➢
You can change modes at any time.
3 To adjust the temperature, press the or buttons on the remote
control one or more times until the required temperature is displayed.
Possible temperatures are between 18°C and 30°C inclusive.
Result: ◆ Each time you press the temperature buttons:
– The temperature is adjusted by 1°C and
displayed on the control panel
– The unit beeps
◆ The air conditioner starts cooling if the room temperature
is higher than the selected temperature.
4 To set the fan speed to... Then...
High Press the button on the remote control.
Low Press the button on the remote control.
Result: Each time you press a button, the unit beeps.
5 To control the direction of the air flow, refer to page 10.
Cooling Your Room
Remote Control Control Panel
E- 8