Sony MDS-NT1 - Manual (Page 16)

16
MDS-NT1
3-5. FRONT PANEL SECTION
3-6. BD BOARD, OVER WRITE HEAD (HR901)
6
2 screw (P1.7 × 6)
3 over write head (HR901)
Note: By means of removing 1 connector (CN104),
BD board can be removed without removing
the over write head (HR901).
Note: The over write head (HR901) should be
handled with care as it is damaged easily.
4 Remove four solders.
4 Remove five solders.
8 BD board
1 connector
(CN104)
7 flexible board (CN101)
5 two screws (PWH1.7 × 3.5)
BD board
(side B)
wire (flat type) (7 core)
Note: Set the wire (flat type) as illustrated,
then install the front panel section.
3 two screws
(K3
× 8)
2 lead wire
4 two screws
(BVTT3
× 5)
1 wire (flat type) (7 core)
(CN104)
5 front panel section