Pre paration for use – Sharp HT-X1 User Manual

Page 21

Advertising
background image

21

HT-X1

Pre

paration

for Use

"

Speaker connection

To prevent accidental short-circuits between and termi-
nals, connect the speaker wires to the speakers first and then
to the subwoofer/amplifier unit.

When connecting speakers, match the colors of the back label
on the speaker, to the tube for the speaker wire, and speaker
terminal of the subwoofer/amplifier unit.

Caution:

!

The supplied speakers are exclusively for the HT-X1. Do not
connect them to other equipment, and do not connect other
speakers to the HT-X1. It may cause malfunction.

!

Do not mistake the and , and right and left terminals of the
speaker wires. (The right speaker is placed on the right when you
face the subwoofer/amplifier unit.)

!

Do not stand or sit on the speakers. You may be injured.

!

Do not allow any objects to fall into or to be placed in the bass
reflex ducts of the subwoofer/amplifier unit.

"

Attaching the optional floor speaker stand

The front speakers and surround speakers support the optional floor
speaker stand (see page 65). Remove the original stand for each
speaker using a screwdriver first. For details, refer to the manual for
the floor speaker stand.

Note:
Keep the removed speaker stands or screw in a safe place.

Make sure to leave the AC power cord disconnected when
connecting the speakers.

Subwoofer/
amplifier unit

Example: To connect the left front speaker.

1

Connect the wires to the speakers.

Red

Red

Black

Black

2

Connect the other end to the
subwoofer/amplifier unit.

Tube (white)

Tube (white)

Speaker
terminal
(white)

Label (white)

!

The speaker grilles are not removable.

!

Do not short-circuit the speaker wire. If it
happens with the power on, the protection
circuit is activated and the system enters the
stand-by mode. In this case, check that the
speaker wire is connected correctly before
turning on the power again.

Incorrect

Advertising