Sharp HT-X1 - Manual (Page 30)

30
HT-X1
D
V
D Oper
ation
Playing a disc (continued)
Notes:
! When you turn on the power or switch the input to "DVD" initial-
ization starts and operation is not possible for a few seconds.
! Stop positions may be recorded on some discs. When you play
such a disc, playback stops there.
! During an operation, " " may appear indicating that the opera-
tion is disabled by the disc.
! Some DVD may not function as described in the manual. See the
disc jacket for restrictions.
! Some CD-R/CD-RW may not play properly due to the status of
the disc or equipment used for recording. Change the recording
speed or disc. For more details, see the manual for the equip-
ment.
! Sound may skip at high volume depending on the disc. In this
case, turn down the volume.
Caution:
! Be careful not to damage the disc when inserting or removing it.
! A disc does not play if damaged, dirty or loaded upside down.
! Make sure to remove the disc before transporting the main unit.
Otherwise the disc inside may cause malfunction.
! Do not let coins, clips, etc. get into the disc insertion slot. Mal-
function may occur.
! When attempting to play discs with scratches or of a different
region number, or unplayable or restricted (*1) discs, an error
message will appear on the TV display and the disc will not play.
" To resume playback after stopping (resume
play)
You can resume playback from the point playback is stopped.
To cancel resume play:
Press the button again.
Notes:
! The resume play feature is disabled on some discs.
! Depending on the disc, playback may resume slightly before the
position where it was stopped.
(*1) Viewing is prohibited on some DVDs according to the audi-
ence age.
1 While the disc is playing, press
the
button.
The system stores the point you stopped.
2 To restart play, press the
(DVD/CD )
button.
Playback resumes from the point you left off.
Pre-Stop
Play
Stop