Sharp AQUOS LC-20B5M - Manual (Page 14)

13
Preset (Continued)
■ Setting a channel to a desired TV station:
Upper control panel
4 1, 2, 6 3
Press MENU (PRESET-1) on the upper part of the
LCD TV set for more than 2 seconds. The AUTO
mode screen appears.
A u t o ( B / G )
V H F 1
4 8 . 2 5 M H z
Press MENU (PRESET-1) to display the MANUAL
mode screen. Press MENU (PRESET-1) again to
change the MANUAL mode as shown below.
Select the channel position using Channel Select or
CH (
)/( ).
M a n u a l ( B / G )
V H F 1
4 8 . 2 5 M H z
Press VOL (+)/(–) to locate the channel you want to
preset to the position. Search is initiated and when a
TV signal is received during the search, the search
stops.
Repeat steps 3 and 4 above, to preset the channel
positions for other broadcasts, etc.
M a n u a l ( B / G )
U H F 5
6 2 3 . 2 5 M H z
Press MENU (PRESET-1) to return to the normal
screen.
NOTE
• SYSTEM may not have been set correctly, if noise can be heard or
if there is no sound. In such case, reset to “Sound system” using
MENU (See page 14).
Presetting the Channels (MANUAL)
■ In a weak reception area, or under bad reception
conditions.
Upper control panel
4 1, 2, 3, 5
Press MENU (PRESET-1) on the upper part of the
LCD TV set for more than 2 seconds. The AUTO
mode screen appears.
Press MENU (PRESET-1) to display the MANUAL
mode screen.
While the MANUAL mode screen is displayed, press
MENU (PRESET-1) for more than 2 seconds.
The channel position number remains in green.
Adjust for good reception using VOL (+)/(–).
After finishing the adjustment, press MENU
(PRESET-1) to continue channel presetting.
NOTE
• While the MANUAL mode screen is displayed, press MENU
(PRESET-1).
(The LANGUAGE mode screen will appear.)
M a n u a l ( B / G )
V H F 1
4 8 . 2 5 M H z
F i n e
U H F 5
6 2 3 . 2 5 M H z
: SELECT O K : ENTER M : BACK E : EXIT
E n g l i s h
1
2
3
4
5
6
1
2
3
4
5
Sound system
AUTO MANUAL LANGUAGE NORMAL SCREEN
LC-15_20B5M_E_P12-15.p65 04.1.30, 11:23 AM 13