Sharp AQUOS LC-20B5M - Manual (Page 32)

31
Rec Mode
Use this setting for recording images you are currently
watching. Select the recording mode (picture quality) for a
motion picture.
Press MENU to display the Menu screen.
Press \/| to select “Card”.
Press '/" to select “Video setup”, and press OK.
M e n u [ C a r d V i d e o s e t u p ]
S e l e c t m o d e
V i d e o s e t u p
T i m e r R e c .
S t i l l s e t u p
F o r m a t
C a r d
Press '/" to select “Rec mode”, and press OK.
: SELECT O K : ENTER M : BACK E : EXIT
M e n u [ C a r d V M e n u [ C a r d V i d e o s e t u p ]
R e c m o d e
P r e - r e c o r d i n g
R e p e a t
S e l e c t e d d e s i r e d i t e m
S l o w m o t i o n
Z o o m S P
E d i t
L P
E P
Press '/" to select “SP”, “LP” or “EP”, and press OK.
Press MENU to exit.
NOTE
• When using the SP mode, differences in picture quality can occur
depending on the card used. In this case, it is recommended to
record in the LP mode.
• When switching to the Card mode after finishing the recording, the
motion picture mode is indicated.
• When switching to the Card mode after finishing recording a still
picture, the still image mode is indicated.
Pre-Recording
When setting pre-recording to “On”, recording will be initiated
starting from 5 seconds earlier.
Press MENU to display the Menu screen.
Press \/| to select “Card”.
Press '/" to select “Video setup”, and press OK.
M e n u [ C a r d V i d e o s e t u p ]
S e l e c t m o d e
V i d e o s e t u p
T i m e r R e c .
S t i l l s e t u p
F o r m a t
C a r d
Press '/" to select “Pre-recording”, and press OK.
: SELECT O K : ENTER M : BACK E : EXIT
M e n u [ C a r d V M e n u [ C a r d V i d e o s e t u p ]
R e c m o d e
P r e - r e c o r d i n g
R e p e a t
S e l e c t e d d e s i r e d i t e m
S l o w m o t i o n
Z o o m
E d i t
O n O f f
Press \/| to select “On”, and press OK.
Press MENU to exit.
NOTE
• Pre-recording is enabled only in the motion picture mode. It is not
possible to capture an image a few seconds before as a still
picture.
When recording with the “Pre-recording” mode set to “On”
• The LAP time at playback will be a few seconds longer than the
LAP time at the end of recording.
• Depending on the timing the recording was started, the time the
pre-recording can return may vary slightly, for example, immedi-
ately after selecting a channel or immediately after turning on the
power.
• When timer recording has been set in “Timer Rec.”, the start time
will not return even if “Pre-recording” is set to “On”.
Recording on a Memory Card (Video Setup)
1
2
3
4
5
6
1
2
3
4
5
6
Selected item
SP
LP
EP
Description
Use this mode for normal use.
Use this mode for making long recordings.
When recording with the LP/EP mode, there is a
bigger difference in the image and sound quality
than recording in the SP mode.
LC-15_20B5M_E_P29-32.p65 04.1.30, 11:41 AM 31