Sony XL-HF200P(BK) - Manual (Page 16)

E-15
Tuner
■
Frequency range FM: 87.5 - 108 MHz
AM: 530 - 1,710 kHz
Preset 40 (FM and AM station)
Speaker
■
Type 2-way type speaker system
1” (2.5 cm) Dome-Tweeter
4-3/4” (12 cm) woofer
Maximum input power 100 W
Rated input power 50 W
Impedance 4 ohms
Dimensions Width: 5 - 13/16” (148 mm)
Height: 16-1/4” (260 mm)
Depth: 8” (203.5 mm)
Weight 5.4 lbs. (2.5 kg)/each
USB
■
USB host interface Complies with USB 1.1 (Full
Speed)/2.0 Mass Storage Class.
Support Bulk only and CBI protocol. ●
●
Support fi le MPEG 1 Layer 3
WMA (Non DRM) ●
●
Bitrate support MP3 (32 ~ 320 kbps)
WMA (64 ~ 160 kbps)
●
●
Other Maximum total number of MP3/WMA
fi les is 1024.
Maximum total number of folders is
255 INCLUSIVE of root directory.
The ID3TAG information supported
are TITLE, ARTIST and ALBUM
only.
Supports ID3TAG version 1 and
version 2. ●
●
●
●
File system support Support USB devices with Microsoft
Windows/DOS/FAT 12/FAT 16/ FAT
32.
2 kbyte block length for sector. ●
●
General
■
Specifi cations
As part of our policy of continuous improvement, SHARP reserves the right
to make design and specifi cation changes for product improvement without
prior notice. The performance specifi cation fi gures indicated are nominal
values of production units. There may be some deviations from these values
in individual units.
Power source AC 120 V ~ 60 Hz
Power consumption 40 W
Dimensions Width: 8 - 1/2” (215 mm)
Height: 3 - 1/2” (90 mm)
Depth: 11 - 4/5” (300 mm)
Weight 8.8 lbs. (4.0 kg)
CD player
■
Type Single disc multi-play compact disc player
Signal readout Non-contact, 3-beam
semiconductor laser pickup
D/A converter Multi bit D/A converter
Frequency response 20 - 20,000 Hz
Dynamic range 90 dB (1 kHz)
Amplifi er
■
Output power RMS: Total 100 watt (50 W per channel
into 4 ohms at 1 kHz, 10% Total
harmonic distortion.)
FTC: 37.5 watt minimum RMS per
channel into 4 ohms from 100 Hz
to 20 kHz, 10% Total harmonic
distortion.
Output terminals Speakers: 4 ohms
20Hz - 20kHz
Subwoofer Pre-out (audio signal):
200 mV/10 k ohms at 70 Hz
Video output: 1 Vp-p
Headphones: 16-50 ohms
(recommended: 32 ohms)
Input terminals Audio In (audio signal):
500 mV/47 k ohms
Line in (Analog input):
500 mV/47 k ohms
Troubleshooting chart (continued)
Care of compact discs ■
Compact discs are fairly resistant to damage, however mistracking can occur
due to an accumulation of dirt on the disc surface. Follow the guidelines below
for maximum enjoyment from your CD collection and player.
Do not write on either side of the disc, particularly the non-label side from
which signals are read. Do not mark this surface.
Keep your discs away from direct sunlight, heat, and excessive
moisture.
Always hold the CDs by the edges. Fingerprints, dirt, or water on the
CDs can cause noise or mistracking. If a CD is dirty or does not play
properly, clean it with a soft, dry cloth, wiping straight out from the center,
along the radius. ●
●
●
Cleaning the cabinet
■
Maintenance
Periodically wipe the cabinet with a soft cloth and a diluted soap solution,
then with a dry cloth.
Caution:
Do not use chemicals for cleaning (gasoline, paint thinner, etc.). It may
damage the cabinet.
Do not apply oil to the inside of the unit. It may cause malfunctions.
●
●
Cleaning the CD pickup lens ■
In order to ensure proper operation of the CD player, preventative maintenance
(cleaning of the laser pickup lens) should be performed periodically. Lens
cleaners are commercially available. Contact your local CD software dealer
for options.
XL-HF200P_USA_EN.indd 15 XL-HF200P_USA_EN.indd 15 7/16/2010 9:11:06 AM 7/16/2010 9:11:06 AM