Sharp AL-1650 - Manual (Page 31)

29
MAKING COPIES 1 Press the INTERRUPT ( ) key.
● The copier will return to the initial settings.
● When the SPF is being used, the copier will stop after completing
copying of the original which has been fed into the SPF.
2 When the copier stops, remove the original(s) and set
the original(s) for interrupt copying.
3 Select the desired available copier functions.
4 Set the number of copies.
5 Press the START ( ) key.
6 When all INTERRUPT copies are finished, press the
INTERRUPT (
) key again to cancel the INTERRUPT
mode, and remove the original used for interrupt copying.
● The previous copy quantity, copy ratio, copy density, and paper size
will be automatically restored.
7 Replace the original for the interrupted job and press the
START (
) key to resume copying.
INTERRUPTING A COPY RUN
INTERRUPT is used to interrupt a long copy run so that another job can be
done.
Interrupting a copy run