Sharp AL-1650 - Manual (Page 44)

42
GENERAL
INFORMA
TION
User programs
USER PROGRAMS
The user programs allow the parameters of certain functions to be set, changed, or
canceled as desired.
List of user programs
This copier has the following user programs.
Program No. Program name Description
1 Auto clear time Sets the auto clear time. The copier returns to the initial settings when
the auto clear time elapses after the last copy is made.
2 Preheat mode Sets the time that elapses before the copier enters the preheat mode after
any operation is made. See page 44.
3 Auto power shut-off Sets the time that elapses before the copier enters the auto power shut-off
timer mode after any operation is made. See page 44.
4 Stream feeding mode Enables or disables the stream feeding mode. For description of the stream
feeding mode, see page 17.
5 Auto power shut-off Enables or disables the auto power shut-off mode. See page 44.
setting
8 Auto paper select mode Enables or disables the auto paper selection. See page 16.
9 Auto tray switching Enables or disables the automatic tray switching which occurs when paper
in a tray runs out. (This switching cannot switch to the bypass tray.)
Setting the user programs
1 Press and hold the light ( ) key for more than 5
seconds until all the alarm indicators ( , , , and
) blink and “– –” appears in the copy quantity display.
2 Enter a program number using the left copy quantity
(
) key.
● The selected program number will blink in the copy quantity display.
● If a mistake is made in steps 2 to 4, press the CLEAR ( ) key. The
copier will return to step 2.
● The program numbers are shown in the table above.
For example, to change the setting of the auto power shut-off timer,
enter 3.