Siemens Gigaset S450 - Manual (Page 7)

6
First Steps
Gigaset S450 / English for Greece / A31008-M1716-T101-1-8U19 / starting.fm / 07.09.2005
Please note:
u The mains adapter must be always
connected, as the phone will not
operate without mains connection.
u If you buy a replacement phone cord
from a store, ensure that the phone
jack is connected correctly.
Setting up the handset for use
Inserting the batteries
¤
Fit the batteries with the correct
polarity (see diagram).
The polarity is indicated in/on the battery
compartment.
Closing the battery cover
¤
First align the notches on the side of
the battery cover with the lugs on the
inside of the casing.
¤
Then press the cover so that it clicks
into place.
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
¤
Press the belt clip onto the back of the
handset so that the protrusions on the
belt clip engage with the notches.
Opening the battery cover
¤
If fitted, remove belt clip.
¤
Insert a fingernail or a small
screwdriver between the notch for the
belt clip and the cover. Lift the whole
cover up and out of the locators.
Correct phone jack assignment
1 unused
2 unused
3 a
4 b
5 unused
6 unused
Caution:
Use only the rechargeable batteries
recommended by Siemens (page 45). Never
use conventional (non-rechargeable)
batteries or other battery types as this may
cause significant damage to health and
property. For example, the outer casing of the
batteries could be destroyed or the batteries
could explode. The phone could also
malfunction or be damaged as a result of
using batteries that are not of the
recommended type.
3
2
1
4
5
6