Sanyo TLS-224P - Manual (Page 26)

OUTPUT TERMINALS
TAPE END OUT Terminal
•
During recording, when the end of the tape is
reached or when the tape counter reading indicates 2
hours 57 minutes or more, the output becomes 0V
(Low).
•
During autorepeat recording, when the end of the
tape is reached, the output become 0V (Low) for
about 2 seconds only.
•
To reset the output, press the STOP or EJECT
button.
TAPE END OUT Terminal Output Setting
1
Press the AUDIO ON/MENU button until the (SET
UP 3) menu is displayed.
2
Press the ] button, until the “TAPE END OUT”
setting is flashing.
3
Press the l (or j ) button, to select the desired
output mode.
–3M. . . . . . . . . . . . The output become 0 V
(Low) when the tape counter
reaches “2:57:00” and/or
when the tape reaches the
end.
END . . . . . . . . . . . The output become 0 V
(Low) when the tape
reaches the end.
4
Press the PAUSE/SCAN button, the normal screen
is displayed.
WARNING OUT Terminal
•
If the tape stops or other problem, the output
becomes 0V (Low).
•
To reset the output, unplug the power cord then plug
it back in or press the ALL RESET button.
NOTE:
•
If the output is 0V (Low) due to the clog detect
function, it can be reset by simply pressing the STOP
button.
COM Terminal
•
Common GND (ground) terminal when connecting
other terminals to external devices.
Tape end or
2
H 57 M 00 S
5V (H)
0V (L)
(Output impedance: 5.7 k Ω )
Output reset
<SET UP 3>
ALARM MODE Y1
ALARM SPEED 3H
ALARM DURATION 20S
TAPE IN MODE STOP
TAPE END MODE REW
TAPE END OUT -3M
CLOG DETECT. Y
Tape movement stop
5V (H)
0V (L)
(Output impedance: 5.7 k Ω )
Output reset
GB
NE4QG/EX (TLS-224P GB) Mon. May, 11/1998
English 25