Sony DR BT160IK - Manual (Page 22)

DR-BT160iK_CED [US, ES] 4-108-812-42(1)
  US US
DR-BT160iK_CED [US, ES] 4-108-812-42(1)
  US US
5
Press and hold the power button of the transmitter for about 7
seconds or more to enter “Pairing in process.”
After about 1 second, the transmitter indicator will flash twice,
but keep pressing the power button.
Notes
When first power on the transmitter after initialized, the transmitter will
enter “Pairing in process” automatically.
The pairing information is initialized if you press and hold the power button
for 15 seconds. The transmitter indicator lights up for 5 seconds before the
initialization starts. Release the button immediately when the transmitter
indicator lights up.
When the transmitter indicator flashes quickly, stop pressing.
The transmitter enters “Pairing in process.”
The transmitter indicator status will vary as follows, and pairing
is established with the Bluetooth receiving device.
The transmitter indicator flashes quickly: Pairing in process

The transmitter indicator flashes (at about 1-second intervals)
when responding to the Bluetooth receiving device: Connectable
(Pairing successful)

The transmitter indicator flashes (at about 5-second intervals):
Connected
Notes
“Pairing in process” of the transmitter is released after about 5 minutes. If
pairing is not established within about 5 minutes, repeat the above procedure
from step . iPod backlight may turn on in this 5 minutes.
To enter “Pairing in process,” you need to turn off the power of the
transmitter first.
When not completed pairing
Repeat the procedure from step .
•
•
•
•