Changing channels-air/cable – Sharp Aquos LC 45GD7U User Manual
Page 32
32
Changing channels-Air/Cable
You can change channels in several ways by pressing
AIR
or
CABLE
to select the antenna and then following
one of the methods below .
Method 1
Using
CH
r
/
s on the remote control unit or on the TV.
Method 2
1. Press
FLASHBACK
to switch to the previously tuned
channel.
2. Press
FLASHBACK
again to switch back to the
currently tuned channel.
NOTE
•
FLASHBACK
will not work if no channel has been
changed after TV is turned on.
Method 3
Using remote control buttons
0–9
,
•
(DOT)
to select
channels for VHF/UHF/CATV/DIGITAL.
To select a 1 or 2-digit channel number
(e. g., Channel 5):
Press 5
s
ENT
NOTE
• When selecting a 1-digit channel number, it is not
necessary to press
0
before the number.
• When you enter
0–9
only, channel selection will be made
if there is no operation for a few seconds.
To select a 3-digit channel number
(e. g., Channel 115):
Press 1
s
1
s
5
NOTE
• When you enter
0–9
only, channel selection will be made
if there is no operation for a few seconds.
• If you push “0” by itself, nothing will happen.
• Complete the above steps within a few seconds.
• When you enter
0–9
and • (DOT), channel selection will
be made if there is no operation for a few seconds.
To select a 4-digit channel number
(e. g., Channel 22.1):
Press 2
s
2
s• (DOT) s1s
ENT
5
Air
5
Air
ANALOG
11
Cable
1
Cable
115
Cable
ANALOG
22 .
Air
Air
DIGITAL
22 . 1
22 . 1
Air
22
Air
2
Air
Method 4
1. Press
INPUT
.
2. Press a/b to select CableBox [TV], and then press
ENTER
.
3. Press
CH
r
/
s to change the channel of the cable
box.
INPUT SOURCE
TV
CableBox [TV]
INPUT1
INPUT2
INPUT3
INPUT4
INPUT5
INPUT5
i.LINK
Watching TV