Samsung SSC-5000 - Manual (Page 15)

English _15
M
INSTRUCTIONS
CAMERA CONTROL
Selecting a camera
Press “CAM” ( ) key. The camera display part of the screen will
be as follows.
Enter the camera number (0~255) you want by using the number key
and press [ENTER] button.
Selecting a monitor
This function is to choose a monitor displaying the image of the camera.
Press the [MON] button.
Enter the monitor number(0~255) that shows the image of the chosen camera and press <Enter>.
PAN/TILT control
Move the joystick of the keyboard to regulate PAN/TILT of the camera.
The speed of the camera movement gets faster when the joystick moves farther from the center.
ZOOM movement
Turn the joystick of the keyboard in a clockwise direction or press the [ZOOM TELE] button to regulate the
ZOOM IN movement.
Turn the joystick of the keyboard in a counterclockwise direction or press the [ZOOM WIDE] button to
regulate the ZOOM OUT movement.
FOCUS movement
Press the [FOCUS FAR] or [FOCUS NEAR] button.
IRIS movement
Press the [IRIS OPEN] or [IRIS CLOSE] button.
AUTO PAN movement
Press the [AUTO PAN] button to move between two points in the camera menu repeatedly.
“AUTO PAN” will appear on the screen. Press the [AUTO PAN] button again to release the auto pan mode.
On models released later than the SCC-C6405, press the [AUTO PAN] button and enter the AUTO PAN number (1~4), then press
the [ENTER] button to execute the AUTO PAN feature.
SCAN movement
This function is to move between the preset positions that were set by the camera's scan mode.
Press [SCAN] button to execute the scan movement and you will see “SCAN” message during the scan
movement. Press the [SCAN] button again to release the scan mode.
On models released later than the SCC-C6405, press the [SCAN] button, and enter the SCAN number (1~4), then press the
[ENTER] button to execute the SCAN feature.
PATTERN movement
This function is to view the camera movement for 30 seconds designated by the user on the pattern mode of
the camera menu.
Press the [PATTERN] button on the keyboard, enter the pattern number(1~3) you want, and press [ENTER]
button to execute PATTERN movement.
“PATTERN 1” will appear on the screen.
On models later than the ALARM VER 1.100, SCC-C6405, movements caught by the camera for 2 minutes will be stored in the
PATTERN feature (1~3). If you are transferring data from and to the camera with SSC-5000, please reset before use since the
PATTERN may differ from the settings.
If there is any of MANUAL (PAN, TILT, ZOOM, FOCUS) input during auto execution (SCAN, AUTO PAN, PATTERN), the system will stop
the AUTO movement and execute the MANUAL movement.
W
1.
2.
W
1.
2.
W
W
W
W
W
M
W
M
W
M
M
CAM
002
MON
002 002