Sundance Spas CONSTANCE 6530-512X - Manual (Page 21)

Page 17
ELITE SERIES
7. Set Spa To Heat
To warm spa water to a comfortable temperature, follow
these steps:
The LED display on the control panel displays the actual •
temperature of the spa water. Press either the COOLER ( ) or
WARMER ( ) button once to display the “set” temperature for
5 seconds. If you want the water to heat to a different temperature,
simply press COOLER or WARMER within 5 seconds. The set
temperature increases or decreases by one degree each time one of
these buttons is pressed.
The heater will turn off when the temperature corresponding to the •
thermostat setting is achieved.
Important Heater details:
• The maximum temperature for which the spa can be set is
104°F (40°C) and the minimum is 65°F (18°C).
• For North American 2-pump spas powered by a 40 amp
service, jets pump #1 must be set to low speed and jets
pump #2 must be turned off to operate the heater.
• For Export (50 Hz) 2-pump spas powered by a 20 amp
service, jet pump #1 must be set to low speed and jets
pump #2 must be turned off to operate the heater.
• Setting the thermostat at maximum will not accelerate the
heating process. This will only result in a higher ultimate
temperature.
• The heater operates until the water reaches the
programmed “set temperature”, then turns off. The heater
will reactivate after the water cools to approximately 1.5°
below the “set temperature”.
8. Place Cover On Spa
Keeping the insulating cover in place anytime the spa is not in •
use will reduce the time required for heating, thereby minimizing
operating costs.
The time required for initial heat-up will vary depending on the •
starting water temperature.
dANGER:
RISK OF PERSONAL INjURY.
Check water temperature carefully before entering hot tub!
Excessive water temperature can cause burns, welts and
body temperature to rise, hyperthermia (over-heating).
!