Samsung DVD-V8000 - Manual (Page 31)

GB
59
Index Scan will fast-forward or rewind to the nearest Index Mark,
play a few seconds of tape, and then fast-forward or rewind to the
next Index Mark. When you find the show you want to watch, press
Play.
Tip: Use this feature with the Date/Time Stamp to quickly find
Timer Recordings on your tapes. For example, when Index Scan
stops at an Index Mark and plays a few seconds of tape, you will
see the date & time the show was recorded.
1 Open “SEARCH MENU”
From Stop or Play mode, press the SEARCH button.
2 Select “Index Search/Scan”
Using the up/down, move the selection arrow to “Index
Search/Scan,” then push right to select.
3 Scan for Index Marks
Press Fast-Forward or Rewind to begin scanning for Index Marks
forwards or backwards.
4 Review the Tape
When Index Scan locates an Index Mark, it will play the tape for 5
seconds. If it is the scene you want to watch, press the Play/Pause
button. If it is not, the VCR will automatically search for the next
Index Mark.
Placing Index Marks
Index Marks are like bookmarks on your videotapes. They are
inserted automatically at the start of every recording, or you can
place them manually anywhere on a tape. Later you can locate
these “bookmarks” using Index Search or Index Scan.
1 Automatic Index Marks
Index Marks are placed automatically whenever you start
recording, including OTR (One Touch Recording), Timer
Recording.
2 Manual Index Marks
You can place an Index Mark manually any time a recording is in
progress by pressing the Mark button on the remote control.
“Index” will flash briefly on the On-Screen Display while the mark is
recorded.
1
2
Index Scan
GB
58
The DVD-VCR Search/Index features allow you to scan and search
for Index Marks, quickly find blank tape, search for tape counter
positions, and return to 0:00:00. The real-time tape counter gives
you real-time feedback on the precise position of your DVDs and
videotapes.
Press the CLOCK/COUNTER button repeatedly to cycle the front
panel display through the following three views:
1 Clock
Shows you the current time as set in the Set Clock menu.
2 Real-Time Counter
Shows you the current counter position in the DVD or VCR deck in
hours, minutes, and seconds.
3 Time Remaining (VHS only)
Shows you the amount of time left on the tape in the VCR deck,
computed by subtracting the current tape position from the total
tape length in hours and minutes.
NOTE: The Clock/Counter/Time Remaining display will not appear
if there is a deck status message on the front panel display.
The Clock/Counter Button
01616A DVD-V8000/TWN-Eng5 8/27/56 8:59 AM Page 58