Sharp AR-162S User Manual

Page 57

Advertising
background image

55

OPTIONAL

EQ

UIPMENT

SINGLE PASS FEEDER (AR-SP2)

Using the SPF

Be sure to remove any staples or paper clips from the
originals.

Damaged or crumpled originals may misfeed in the SPF.
It is recommended that these originals be copied from the
original table.

Before placing curled or wavy originals into the document
feeder tray, be sure to flatten them. If not, original misfeeds
may result.

For best feeding of originals which have binding holes
punched into them, insert them so that the holes are
positioned to the right or along the side guides.

Special originals such as transparency film and tracing
paper should not be fed through the SPF but should be
copied from the original table.

Single pass feeder (AR-SP2)

Stream feeding mode
If the stream feeding mode has been enabled using user program
No. 4, the SPF indicator will continue to blink for approximately
5 seconds after feeding of all originals is completed. While this
indicator is blinking, any new originals placed in the SPF will be
fed and copied automatically. See page 35, USER PROGRAMS.

1

Ensure that no original is left on the original table.

2

Adjust the original guides to the size of the originals.

3

Set the originals face up in the document feeder tray.

The SPF indicator will light up. If this indicator does not light up, the
originals are not properly set or the SPF is not properly closed.

4

Ensure that the copy paper size in the paper tray is the
same size as the originals.

5

Press the START key.

Since only one copy per original can be made, the number of copies
cannot be changed.

Press the CLEAR key to stop copying in the middle of a run.

While making copies from the SPF, do not place
originals of the next copying job. Place them after all
copies of the current job have been output.

Advertising