Samsung ML-1430 - Manual (Page 119)

A.8 A
PPENDIX
Double side-seam construction has vertical seams at both ends
of the envelope rather than diagonal seams. This style may be
more likely to wrinkle. Insure the seam extends all the way to
the corner of the envelope as illustrated below. Envelopes with
Double Side Seams
Envelopes with a peel-off adhesive strip or with more than one
flap that folds over must use adhesive compatible with the heat
and pressure in the printer. The extra flaps and strips may cause
wrinkling, creasing, or even jams and may even damage the
fuser. Envelopes with
Adhesive Strips or
Flaps
The following gives typical address margins for a commercial
#10 or DL envelope. Envelope Margins
Proper storage of envelopes helps contribute to print quality.
Envelopes should be stored flat. If air is trapped in an envelope,
creating an air bubble, then the envelope may wrinkle during
printing. See “Printing on Envelopes” on page
4.7 .
Envelope Storage
Correct
Incorrect
Top margin Type of Address
Return address
Delivery address
Left margin
15 mm (0.6 in.) 15 mm (0.6 in.)
89 mm (3.5 in.) 51 mm (2 in.)
Notes:
• For best print quality, position margins no closer than 15 mm
(0.6 in.) from the edges of the envelope.
• Avoid printing over the area where the envelope’s seams meet.
Paper Specifications