SMC Networks Gateway TTTM5800X - Manual (Page 10)

All Rights Reserved. Copyright 2006 Teletronics International, Inc.
2 Choke Cherry Road, Rockville, MD 20850 Tel: 301.309.8500 Fax: 301.309.8851
Preparation for Installation
Always double check for any missing parts from the kit you received before deployment.
Next step is to set up the computer Ethernet interface for configuring the TT™5800X/TT™2400X. you’ll need to set the
computer Ethernet interface within the same IP range as your TT™5800X/TT™2400X.
Check the following section - “Hardware Installation” and the next chapter - “Configuring Windows for IP Networking” to
obtain complete details.
Hardware Installation
Follow the procedure below to install your TT™5800X/TT™2400X device:
1. Select a suitable place on the network to install the TT™5800X/TT™2400X. For best wireless reception and
performance the external antenna should be positioned within Line of Sight from the AP with proper alignment.
2. Connect the TT™5800X/TT™2400X to the ODU side of the PoE Injector, via a straight Ethernet cable (Cat-5),
and then connect the NET side of the PoE Injector to either a computer or an Ethernet Switch. Note: The
TT™5800X/TT™2400X now fully supports the MDI/MDI-X standard and no longer requires the use of cross over
cable to connect directly with a computer.
3. Connect the 48VDC power adapter to the power jack on the PoE injector to power on the
TT™5800X/TT™2400X.
4. Check the LEDs on the TT™5800X/TT™2400X to confirm if the status is okay. At this point the Power LED
should be on in Red and Ethernet should be on in Green. The RF light should light up once the unit is associated
wirelessly with another wireless device. However at this point the unit is still in factory default setting so do not
alarm if the RF light doesn’t light up.
5. Now the hardware installation is complete, and you may proceed to the next chapter –“Configuring Windows for
IP Networking” for instruction on setting up network configurations.
Configuring Windows for IP Networking