Sony CMTBX5BT - Manual (Page 26)

CMT-BX5BT.GB.3-095-507-11(1)
 GB
Starting playback takes more time
than usual.
 The following discs take a longer time
to start playback.
 a disc recorded with a complicated
tree structure.
 a disc recorded in multisession
mode.
 a disc that has not been finalized (a
disc to which data can be added).
 a disc that has many folders.
Bluetooth device
Pairing cannot be done.
 Move the Bluetooth device closer to
the system.
 Pairing may not be possible if other
Bluetooth devices are present around
the system. In this case, turn off the
other Bluetooth devices.
Connection is not possible.
 The Bluetooth device you attempted
to connect does not support the A2DP
and AVRCP profiles, and cannot be
connected with the system.
 Enable the Bluetooth function of the
Bluetooth device.
 The pairing registration information
has been erased. Perform the pairing
operation again.
 While connected to a Bluetooth device,
this system cannot be detected and a
connection cannot be established from
another Bluetooth device.
The sound skips or fluctuates, or the
connection is lost.
 The system and the Bluetooth device
are too far apart.
 If there are obstacles between the
system and your Bluetooth device,
remove or avoid the obstacles.
 If there is equipment that generates
electromagnetic radiation, such as a
wireless LAN, other Bluetooth device,
or a microwave oven nearby, move
them away.
The sound of your Bluetooth device
cannot be heard on this system.
 Turn up the volume on your Bluetooth
device first, and then adjust the volume
using VOLUME +/  .
Severe hum or noise
 If there are obstacles between the
system and your Bluetooth device,
remove or avoid the obstacles.
 If there is equipment that generates
electromagnetic radiation, such as a
wireless LAN, other Bluetooth device,
or a microwave oven nearby, move
them away.
 Turn down the volume of the
connected Bluetooth device.
The sound from the Bluetooth
headphones is distorted.
 Turn down the volume of the system
using VOLUME   . If your
headphones have a volume control,
also adjust the volume using the
headphone’s volume control.
 Press DSGX  on the unit repeatedly
until “DSGX OFF” appears.
 Press EQ  repeatedly to select
“BASS” or “TREBLE,” and then press
  repeatedly to turn down the
level.
Tuner
Severe hum or noise, or stations
cannot be received. (“TUNED” or “ST”
flashes on the display.)
 Connect the antenna properly.
 Find a location and an orientation that
provide good reception, and then set
up the antenna again.